APM 2.5.2 Flight Controller For Multicopters Helicopters Airplanes
Autopilot Flight Controller with GPS Mega Multi-rotor
Autopilot Flight Controller,the most advanced IMU-based open source autopilot available today,and provides an
entire UAV control system with sciptable missions with 3D waypoints,in-flight uploading of commands and powerful ground
station software.APM 2.5 has been welded at the factory completed, you just need to use the Mission Planner to load the firmware you want to.
Free open source firmware supports planes,multicopters (quads,hex,oct,etc),helicopters and ground rovers!
Simple setup process and firmware loading via a point-and-click utility.No programming required! (But if you do want to fiddle with the code,you can with the easiest embedded programming toolkit available: Arduino).
Full mission scripting with point-and-click desktop utilities.
Can support hundreds of 3D waypoints.
Two-way telemetry and in-flight command using the powerful MAVLink protocol.
Choice of free Ground Stations, including the state-of-the-art HK GCS, which includes mission planning, in-air parameter setting, on-board video display, voice synthesis, and full datalogging with replay.
Autonomous takeoff, landing and special action commands such as video and camera controls.
Supports full “hardware-in-the-loop” simulation with Xplane and Flight Gear.
Autopilot Flight Controller Hardware:
Barometric pressure sensor for altitude
10Hz GPS module
Voltage sensors for battery status
4GB of onboard datalogging memory.Missions are automatically datalogged and can be exported to KML
Built-in hardware failsafe processor,can return-to-launch on radio loss.
Include relay can trigger any device,can be controlled by mission scripts.
(Optional) 3-axis magnetometer
(Optional) Airspeed sensor
(Optional) Current sensor
- Easy to set up and use
- 3D waypoints